These are delightful and very easy to make as well as being very effective
you will need
1 vintage tea towel /guest hand towel with interesting design and edges
white cotton muslin
Iron tea towel flat.
Turn the top edge of the tea towel down to make the front flap of the pillow. Make sure motif is showing.
Take bottom edge of the tea towel and fold up so that 2 inches show out from under the top flap.
Cut a piece of muslin to match the width of the tea towel and 2 inches longer than the crease at the top of the pillow.
With RIGHT sides together, pin the bottom of the tea towel to the bottom of the muslin. Stitch tea towel and muslin together.
Cut off excess fabric and press seams open.
Using the fold lines at the top and bottom of your tea towel, fold fabric the opposite way, so that RIGHT sides are together and the motif is facing inward.
Fold up bottom of tea towel with attched muslin. Pin all around the pillow. The top layer will be muslin with the tea towel bottom, the middle layer will have the pinned up front flap with design and the bottom layer will be the tea towel back.
Leave a 2-3 inch opening at the side of the pillow that will be covered by the front flap. I used a fabric marking pen to remind me where to begin and end sewing.
Sew around the pillow, leaving tthe 2-3 inch opening. I use the side edge of the pillow determine my seam allowances. At the top I use a very small seam allowance so the flap will lay nicely.
Reinforce the ends very well as you will be using this whole to pull the pillow to the right side and to stuff it.
Fill pillow with fiber fill. Make sure corners are filled. Do not over stuff.
Close opening on the side with a whip stitch.
Press again, but do not press too hard. Gently tack down flap if desired. Press again. Fluff and find your pillow a home!